MAGNETS, General knowledge...
Magnets have a NORTH- and a SOUTH pole.
The FLUX is steady, and do not move - it is just there.
Some materials act as a shield for the FLUX.
EX. MU-METAL, PERMALLOY
If you would
try to use the FLUX-power in a magnet, then we must try to make the FLUX
pulsing.
You cane imagine what I mean by setting a Mu-metallic plate, and move it again. By doing that repeatedly, you would be able to detect a pulse every time you put in the shield - ex. on an AC-meter or Oscilloscope, every time you move the shield. Se next image... |
HOW ?
Try this:
Move the Mu-metallic
plate, and put it back multiply times and you will se a little
movement on the Voltmeter or Oscilloscope. OK, here we touched the law of electromagnetic force, recognized by the Danish H. C. Ørsted in 1820. The magnetic FLUX cane make a pulse in a solenoid by moving a Mu-metallic plate in and out of the Magnetic FLUX! |
Can we do that in other ways ?
YES we can!
Her I use a battery and a switch. Every time I open and close the switch, I open and close for magnetic FLUX true the AIR gab. CLOSE the switch I close for MAGNETIC FLUX. BUT.... ONLY AS A PULSE! |
How can we use that ?
With OPEN
switch the magnet would make a magnetic FLUX in the FERRITE or SOFT IRON
bar, AND MAKE A PULSE! With CLOSED switch, the solenoid make a magnetic FLUX, blocking for the FLUX from the magnet, AND MAKE A PULSE! Easy to try... |
How do I monitor the OUTPUT of FLUX into the FERRITE-core ?
By adjusting the frequency
in NE555 until I find a good output, and the AC Voltmeter will show some
output.
In my test-setup I could measure 130 Volt AC, depending on the affectivity of the function on OPEN and CLOSE by the pulse. I may build in a buffer between NE555 and the FETT. |
Until now, I just get familiarly with some fundamental skills about magnets and electromagnetism.
Where do I go from here ?
Wouldn't it be nice, if I could take the AC current, rectifier it, and use it as supply for the generator ?
I shut be an OVER UNITY GENERATOR, WAW... Have to test it...